Technical consultation：
sales@drymixer.com
- 1. High Uniformity
- 2. Short mixing time,High Efficiency
- 3. 80% loading rate
- 4. Time saving,Energy saving,Space saving,Money saving.
- 5 Small damage to the original appearance of powders.
- 6. Solve the problem of ultra-fine powder mixing.
- 7. Solve the problem of light-heavy powder mixing.
- 8. Effectively solve the problem of uniform mixing diffuculty of trace elements
- 1. The important factor influenci
- 2. Particle size - an important
- 3. Powder fluidity is a double-edged sword
- 4. Pretreatment of powder mixture
- 5. Powder mixing principle introduce
- 6. Traditional powder mixers' adv
- 7. Selection of blending equipment
- 8. The basis of the uniform blending of powder
- 9. How to find the cause of mixing bad uniformity
- 10. Super light powder mixing precautions
- 11. Super fine powder mixing precautions
- 12. How to mix bad liquidity powder?
- 13. How to mix trace elements
- 14. A solution for powder's good
- 15. How does the dummy particles
Tech KnowledgeTechnical
How to replace silicon molybdenum rod？
input time：2021-04-02 10:20:24 hits：
When the 1700 degree furnace does not heat up, please check the silicon molybdenum rod first. If there is a problem with the silicon molybdenum rod, please replace it in time. Our company uses high-purity silicon molybdenum rods for sintering zirconia, which will not cause any pollution to zirconia crowns or bridges. Since silicon molybdenum rods are vulnerable parts, please be careful when replacing silicon molybdenum rods. Today I will teach you how to replace the silicon molybdenum rod heating element:
1.Use a screwdriver to unscrew the iron cover of the stove top and remove the top cover.
2.Unscrew the screw of the stainless steel clip on the top of the silicon molybdenum rod and remove the clip.
3.Remove the braid.
4.Take out the broken silicon molybdenum rod directly and remove the stainless steel ceramic card.
5.Carefully remove the stick plug.
6.Replace with a new silicon-molybdenum rod, and fix the stainless steel ceramic clip, braided belt and stainless steel clip in turn.
note! When fixing the braided belt and stainless steel clip on the cold end of the silicon molybdenum rod, it must be tightened to prevent the cold end of the silicon molybdenum rod from being fired due to poor contact. Every 3 months of use, please fasten a certain braid and stainless steel clip to prevent continuous thermal expansion and contraction resulting in poor contact.
note! When fixing the braided belt and stainless steel clip on the cold end of the silicon molybdenum rod, it must be tightened to prevent the cold end of the silicon molybdenum rod from being fired due to poor contact. Every 3 months of use, please fasten a certain braid and stainless steel clip to prevent continuous thermal expansion and contraction resulting in poor contact.
DIASRIOUTION NETWORK